PowerTech listens across RF, Wi-Fi, BLE and Remote ID to detect, locate and identify drones by their own signals — silently, legally, and down to the serial number. No radar. No jamming. Nothing that gives your position away.
Cheap, quiet and hard to see, consumer drones cross fences and perimeters in seconds — and most sites never know they were there.
Drones drop phones, narcotics and weapons into secured yards, bypassing every ground checkpoint on the property.
Cameras overhead map guard rotations, entry points and blind spots — reconnaissance for a later intrusion.
An unauthorized drone near a runway, substation or crowd can halt operations or cause real harm in minutes.
Drones and their controllers constantly announce themselves across the spectrum. PowerTech runs multiple software-defined receivers in parallel and correlates what they hear.
Wideband SDR sweeps flag the control and video links drones use, including bursty and hopping signals.
Monitor-mode capture reads drone and controller MACs, OUIs and beacons — even as addresses rotate.
Continuity and advertising traffic surface nearby devices and Remote ID broadcasts, including Coded PHY.
Decodes DJI DroneID and the Remote ID standard to pull operator location, position and serial number.
Signal fusion. Any one radio can be fooled. PowerTech cross-references detections across all four vectors, links rotating identifiers back to a single aircraft, and raises one confident alert instead of a wall of noise.
Where a drone broadcasts Remote ID, PowerTech decodes it and captures the aircraft's serial number — a concrete, attributable identifier for your report.
Detections plot on a real-time map with signal-strength distance estimates and directional bearing to help point you toward the source.
Fused detections trigger instant dashboard and notification alerts the moment a drone enters your monitored airspace.
Every detection is time-stamped and stored — building a searchable history of drone activity over your site for pattern analysis and evidence.
Add satellite receivers to extend coverage across a large perimeter, all reporting into one unified operations dashboard.
Monitor the whole system from any browser on your network — no proprietary console or dedicated workstation required.
Radar and RF-jamming systems transmit — which means they can be detected, they can interfere with licensed spectrum, and active countermeasures are heavily restricted. PowerTech only listens.
No towers. No trenching. No permits. PowerTech runs on compact hardware you can carry in, mount in a vehicle, or set down and reposition in minutes — and you watch the airspace from any device on your network.
A self-contained sensor kit — no fixed installation, cabling runs, or construction.
Runs on a battery pack or vehicle power. Drop it exactly where you need eyes on the sky.
Power on and it starts listening. Reposition between sites as the threat moves.
Secure remote access puts the live dashboard on your phone, tablet, or laptop — on-site or off.
Stop contraband drops before they land and attribute the aircraft behind them.
Watch airspace over substations, water, refineries and data centers around the clock.
Get early warning of drones near approach paths and active runways.
Protect stadiums, rallies and gatherings from overhead surveillance and disruption.
Monitor long, remote boundaries with distributed low-power sensor nodes.
Add a quiet, always-on RF layer to secured campuses and protective details.
Tell us about your site and we'll set up a walkthrough of the live dashboard and a detection demo.